Notes A. USB device drivers are supplied with Windows XP Home or Professional and Windows Vista. If you have a USB-capable USB device, this charger can be used to charge it. B. If the USB device is not powered by the charger, it will charge both battery and the charger. When charging the charger, only the USB current is used.
LED The 4.5W LED flashlight as 14.4 V battery charging indicator. Notes The battery charger operates at a constant charging current of about 30 mA. The state of charge indicator shows the battery charging rate. The indicator will flash in sequence as the battery charge current passes through 25%, 50%, 75%, 100% during charging. 1. Press the ON button. 2. Keep pressing the buttons until the red indicator light stops flashing, and the LED turns solid. 3. Press the buttons again to see if the LED starts flashing. 4. Turn the charger off. 5. Disconnect the battery and put it in the flashlight.
Adjustable 12A output power range 30 to 60A, 500WATT MAX, 100A ENGINE START capable. Lithium, Nickel Cadmium, AGM and 13.2V batteries require a separate charging system in addition to the this charger. In most cases, this charger will work fine with your existing system, however more capacity may be required, along with some adjustments to the charger settings.
Balanced charging: more even charging. Energizer transformers, and many nickel-cadmium batteries lack a balance charging system. As a result, these batteries build up a lot of power due to the high concentration of negative side charge. This charger will equalize the charge during any load and prevent the battery from becoming over charged. In addition, it can help extend battery life.
the charging sequence for the battery is as follows: when the battery is inserted into the battery charger 11, the led flasher will illuminate. the led flasher will display the battery voltage and the charging current. the charging current is always displayed in percent. while charging, the battery voltage is displayed in mv and shows, if the charge level of the battery is increasing or decreasing. when the system is fully charged, the led flasher will stop flashing and the battery status will be displayed on the indicator plate. the battery indicator will show, if the battery is fully charged or if the battery has passed the charge level of 4.2v. the led flasher will change colours for the charge level 4.2v and below. in the standby mode, the battery voltage will be displayed and the system will wait until the battery is fully charged. when the battery reaches the charge level of 4.2v, the led flasher will illuminate. the battery will be charged until the voltage level is 4.2v. the red led indicates the charge level that should not be exceeded. if the charge level exceeds 4.2v, the red led will flash until the charge level is lower than 4.2v. the charge level is indicated by a blue led. the charging current can be set to the values 50ma, 90ma, 110ma, 130ma and 150ma. the charging current will be displayed on the indicator plate. the charging current is limited to the switch 1 and can be set to the following: off, min 1ma, max 1ma, min 2ma, max 2ma and min 4ma, max 4ma. the maximum charging voltage is 5v. the battery charger 11 protects the battery from overcharging. the overcharging protection will be indicated by a led. the battery status will be displayed on the led flasher and the indicator plate. the led will flash and the led will illuminate. ۵ec8ef588b